Klutch 49414, Руководство пользователя

Страница: 18 / 24

Page 18 of 24
Operating Instructions
1. Place the Cement Mixer on a solid, level surface.
2. Connect the Power Cord (44) to an electric outlet (or properly rated grounded three prong
extension cord).
3. Add material to the Drum. Typical maximum quantities include: 1 gallon water with 2 shovels of
cement and 8 shovels of aggregate rock (using a size 3 shovel, not included).
4. Do not attempt to move the Cement Mixer when it is full and/or in operation. Injury to personnel
could occur.
5. Adjust the Drum angle by pulling on the Degree Adjusting Wheel (20). First, disengage the locking
pins on the Iron Tube Fixture (15) and push on Arm until the desired angle is reached. Re-engage
the locking pins.
6. Flip the power switch to the ON position.
Maintenance
Maintain the Cement Mixer by adopting a program of conscientious repair and maintenance in
accordance with the following recommended procedures:
•
After each use, immediately wash out all debris from the inside and outside of the Cement Mixer.
•
Keep the motor clean and free of buildup.
•
Do not apply water in or around the Motor Base Cover.
•
Retighten belt after the every 25 hours of use. The belt should be able to be pressed in no more
than 1/4".
•
Periodically recheck all nuts, bolts, and screws for tightness.
•
Lightly grease all moving parts.