Klutch 399444, Руководство оператора

Страница: 7 / 12

7
OPERATION
SAVE THESE INSTRUCTIONS
WARNiNG:
MISUSE or failure to follow the safety rules stated in this instruction manual
may cause serious personal injury.
WARNiNG:
Before plugging in the tool, always check to see that the tool is switched off.
WARNiNG:
The switch can be locked in “ON” position for ease of operator comfort
during extended use. Apply caution when locking tool in “ON” position and maintain a firm grasp on
the tool.
SWITCH ACTION:
Caution : This tool has a safety feature on switch to prevent from accidently turning on.
1. To start the tool, first press downward on the rear end of switch , then slide the switch
forward to the (ON) position.
2. For continuous operation, press the front of slide switch downward to lock it on.
3. To stop the tool, press downward on the rear of slide switch, the switch will return to the
"OFF posistion.
INSTALLING THE AUXILLARY HANDLE:
WARNiNG:
Always be sure that the tool is switched off and unplugged before
performing any work on the tool.
Your grinder is equipped with a three position auxillary handle; it can be mounted on either
the left, top or right side of the die cast gear housing. Generally, a right handed operator
will grip the body of the grinder with their right hand and grip auxillary handle, mounted to
the left side of the gear housing, with their left hand. The opposite gripping and auxillary
handle placement is generally used by a left handed operator. Occasionally, auxillary handle
placement needs to be changed to accommodate the requirements or restrictions of the
operation being performed.
To mount the auxillary handle to the grinder, simply securely screw the handle into the
threaded hole on the left, top or right side of the die cast gear housing.
INSTALLING OR REMOVING WHEEL GUARD:
WARNiNG:
Always be sure that the tool is switched off and unplugged before
performing any work on the tool.
1. To mount the wheel guard, loosen the clamp lever on wheel guard's band.
2. Align the small protrusion on the inside of the wheel guard band with the notch on the grinders
bearing cap shoulder, then slip the guard's band onto the shoulder of the bearing cap.
3. Slightly rotate the guard so that it is positioned as shown in the figure on the last page of this
manual.
4. Tighten the clamp lever securely.
5. To remove the guard, follow the installation procedure in reverse.
WARNiNG:
When using a depressed center grinding wheel, flex wheel, wire wheel, cut-
off wheel, or abrasive mop disc, the wheel guard must be fitted on the tool so that the closed side of
the guard always points towards the operator.
INSTALLING OR REMOVING DEPRESSED CENTER GRINDING WHEELS: