Klutch 25954, Руководство пользователя

Страница: 6 / 11

Page of 11 6
To start the tool, simply pull the switch trigger. Tool speed is increased by increasing
pressure on the switch trigger. Release the switch trigger to stop.
CAUTION: Always be sure that the tool is switched off and the battery pack is
removed before adjusting or checking function on the tool.
INSTALLING OR REMOVING BATTERY PACK
 Always switch off the tool before insertion or removal of the battery pack.
 To remove the battery pack, withdraw it from the tool while pressing the buttons on both
sides of the cartridge.
 To insert the battery pack, align the tongue on the battery pack with the groove in the
housing and slip it into place. Always insert it all the way until it locks in place — you will
hear a click when pack is properly engaged. If tool is not properly engaged, it may
accidentally fall out of the tool, causing injury to you or someone around you.

Do not use force when inserting the battery pack. If the pack does not slide in easily, it is not
being inserted correctly.
CHARGING

Plug the battery charger into the proper AC voltage source. The charging light will flash in
green color.

Insert the battery pack so that the plus and minus terminals on the battery pack are on the
same sides as their respective markings on the charger. Insert the cartridge fully into the
port so that it rests on the charger port floor.
 When the battery pack is inserted, push yellow oval “set” button to start charging. The
charging light color is red. The charging light will remain lit steadily during charging.
 When the charging light color changes from red to green, the charging cycle is complete.
 If you leave the battery pack in the charger after the charging cycle is complete, the charger
will switch into its “trickle charge (maintenance charge)” mode.
 After charging, unplug the charger from the power source.
NOTE
 The battery charger is for charging battery pack. Never use it for other purposes or for other
manufacturer’s batteries.
 When you charge a new battery pack or a battery pack that has not been used for a long
period of time, it may not accept a full charge initially. This is a normal condition and does
not indicate a problem with the battery or the charger. You can recharge the battery pack
fully after discharging it completely and recharging a couple of times.