GETTING STARTED
1. Protect all painted surfaces and passing lamps, if equipped, with a soft cloth
2. Remove seat and disconnect negative battery terminal
(Picture 1)
a. On 2009 and later models it will help to remove the two T40 bolts and the
ECM and tray
(Picture 2)
3. Remove windshield and outer fairing
a. Remove the three windshield fasteners
(Picture 3)
b. Remove the four T27 fairing fasteners and disconnect the headlamp
(Picture 4)
(There are two as shown in Pic 4 and two located between the fork and the frame
SPEAKER REMOVAL/INSTALLATION
1. Unplug both terminals at left and right side speakers
(Pic 1)
2. Remove the three T25 fasteners that secure each speaker to the inner fairing
(Pic 1)
3. If using the Kicker grilles, peel the stock speaker grilles off of the speaker stand-off
4. Separate the speaker from the stand-off, it’s a snap fit
(Pic 2)
FOR 6 1/2” SPEAKERS:
a. Install your grills and factory speaker stand-offs back on to the inner fairing.
b. Install the provided Metra Adaptor Rings, per Metra’s installation instructions.
(Pic 3)
6. Insert your Kicker speaker into the stand-off, making sure the terminals are on the top side
7. Now is the time to install your Kicker emblems into the Kicker grilles, if using
a. Place emblem into grille and bend tabs over
8. Lay the grille over the speaker and refasten the speaker to the inner fairing using the hardware removed in step 2.
AMP INSTALLATION
1. Disconnect the radio harness and antenna from the radio
(Pic 1)
2. Remove the two T20 fasteners at the top of the radio chassis
(Pic 1)
a. If using on a radio with CB and/or XM modules, remove the modules from the radio at this time
3. Fasten the amplifier to the bracket using supplied hardware and orient with connector to the left side of the
motorcycle
(Pic 2)
4. Making sure all wiring is safely out of the way, slide the amp bracket over the radio chassis and engage tabs on amp
bracket into the rubber grommets on the radio
(Pic 3)
5. Reinstall the T20 fasteners, removed in step 2, through the amp bracket and into the radio
(Pic 3)
6. To reinstall modules, slide them under the radio chassis and fasten to the tabs on the amplifier bracket with
supplied hardware.
KLOCK WERKS | FLHT KICKER AMP AND SPEAKER INSTALLATION
4
3
2
1
2
3
1
MAKE SURE GAIN SETTING ON AMPLIFIER IS SET TO 0
IMPORTANT INSTALLATION NOTE:
Over-tightening mounting fasteners may result
in damage to your motorcycle. Please refer to
your service manual for proper procedures and
torque specifications. We cannot be responsible
for damage resulting from improper installation
techniques. This kit may not be compatible with
some aftermarket head units.
(amp installation continued on next page)
