Klipsch Palladium P-312W, Руководство пользователя

Страница: 4 / 16

Page 4
Preparing the Loudspeaker
Connection Procedure:
There is a specific procedure to be followed:
• Switch off and unplug the amplifier/s and all source electronics from the mains power.
• Place the subwoofer in the general area where you want it.
• Connect the subwoofer following the instructions under the “connecting the subwoofer” section of this manual.
• Finalize the position of the loudspeakers.
• Fit the front grille (if desired)
TAKE CARE NOT TO TOUCH THE DRIVE UNITS WHEN YOU MOVE THE SUBWOOFER AROUND.
TO PRESERVE THE FINISH, WHEN HANDLING YOUR SUBWOOFER USE THE GLOVES THAT ARE PROVIDED.
Fitting and Removing the Grilles
To fit the front grille: align the posts on the grille with the
post cups on the front of the subwoofer and gently press
on the grille. Use care to ensure that the grille clears the
aluminum control panel extrusion area around the logo.
Do not strike or forcibly press on the grille or grille posts
as damage to the grille or finish of your subwoofer could
occur.
The round side grilles cover the two passive radiators and
come pre-installed from the factory. They are attached via
rubber capture posts to special fasteners on the passive
radiators. If these grilles should ever need to be re-
installed, make sure you orient them properly so that the
curve of the grille follows the curve of the subwoofer side
panel and gently press them back into place.
Although operating the P-312W subwoofer with the front grille on or off is a matter of personal taste, moving
or connecting the subwoofer should always be done with the front grille removed. Be especially careful not to
touch the drive unit.