Klipsch KMC2, Инструкция по установке и эксплуатации

Страница: 3 / 16

KMC2
1
WARNINGS AND COMPLIANCE
Important Safety Instructions
•
To ensure full satisfaction with the product, please read the entire
instruction manual.
•
Keep instructions for future reference.
•
Follow all operation guidelines and adhere to all safety warnings and
cautions to ensure safe use.
•
Do not install near any heat sources such as radiators, heat registers,
stoves, or other apparatus (including amplifiers) that produce heat.
•
Only use attachments/accessories specified by the manufacturer.
•
Never use harsh cleaning agents. Clean only with a dry cloth.
When Operating Vessel
•
Keep the volume level low enough to be aware of your surroundings.
Protect from Submersion
•
Do not submerge, as this can cause electrical shorts, fire or other damage.
Protect from High Temperatures
•
The space behind the chosen mounting location should allow room for the
radios heatsink to dissipate heat generated under normal use. Do not mount
the radio within close proximity of the engine compartment.
Use the Proper Power Supply
•
This product is designed to operate with a 12 volt DC negative ground
battery system.
WARNING:
•
DO NOT OPEN, DISASSEMBLE OR ALTER THE UNIT IN ANY WAY.
Doing so may result in fire, electric shock or product damage.
•
USE THE CORRECT AMPERE RATING WHEN REPLACING FUSE.
Failure to do so may result in fire, electric shock or product damage.
•
DO NOT INSTALL IN LOCATIONS THAT MIGHT HINDER VEHICLE
OPERATION. Doing so may obstruct vision or hamper movement which can
result in a serious accident.
•
INSTALL THE WIRING SO THAT IT IS NOT CRIMPED OR PINCHED BY
SCREWS ORSHARP METAL EDGES. Route the cables away from moving
parts or sharp pointed edges. This will prevent crimping and damage to the
wiring. If the wiring must pass through a metal hole, be sure to use a rubber
grommet to prevent the wire's insulation from being cut by the metal edge of
the hole. It is also recommended to apply sealing caulk to any opening that
may potentially allow water to enter. Be sure to choose a location that is flat
and has clearance above the unit to prevent any damage, as well as allow
for ventilation.
•
Before drilling any holes, carefully inspect the area underneath and behind
the mounting surface where the device will be mounted to make sure it will
not interfere with existing wires, fuel lines, the fuel tank or any other objects
that could be damaged.
•
Always disconnect the vehicle negative battery terminal during installation to
prevent accidental shorting.
Compliance with FCC Rules (U.S.A Only)
This device complies with Part 15 of the FCC rules. Operation is subjected to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
NOTICE
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against Harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful Interference to radio communications.
FCC WARNING
•
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.