Klimatronic FUSION plus, Руководство пользователя

Страница: 19 / 152

Water drainage
1.Manual drainage :
1.1 When water tank is full and unit stop working, please shut off the unit and unplug
Please don’t move the model sharply, or the water will spilt out from water received plate.
1.2 Use a water container to take water under the water plug.
1.3 Screw off the water plug and unplug the water blocker, water will come out to the water container.
2. Continue drainage:
2.1 Screw off the water plug and unplug the water blocker.
2.2 Use water pipe to connect the water outlet. Lead the pipe to the outside or washroom.
Remark: 1.This method can be done only if there is no water in the water received plate.
2.3This model have self evaporative function, under cooling mode, please don’t use continue drainage to get
better cooling effect
.
Cleaning
Please shut off the unit and unplug the plug before cleaning or maintenance
Clean the surface
Clean the housing with a duster or a soft wet cloth. Do not use chemical
solvent (such as benzene, alcohol, gasoline). The surface may be
damaged or even the whole case may be deformed.
1. Air filter cleaning
1.1Clean the air filters every 2 weeks. If the air filter is blocked with dust,
the efficiency will reduce.
1) Pull out up and down filter as below pictures
2) Wash the air filters by immersing it gently into warm (about 40
℃
) water
with a neutral detergent, rinse it and dry it thoroughly in a shaded place
。
3) Install air filters carefully after cleaning the filters.
Storage
1. Pull out the plug in drainage hole and empty the water-received plate, or drain out the water by leaning the unit,
then shift the unit mode to Fan mode, and press the button for 5 seconds till it to low fan speed. Keep this mode for
half day till the conduit is dried. Doing like this can keep the inner unit dried and not go moldy.
2. Turn off the unit and pull out the plug.
3. Coil the wire and bind it together, then put it into the accessories room.
4. Separate the air-exhausted pipe and safely keep it.
5. Put the unit into a plastic bag, then keep it in a dried place.
6. Take out the batteries of remote control and safely keep them.
Trouble Shooting
Don’t repair or disassemble the unit by yourself, unsuitable repair may make the quality-protected card in vain,
and even cause damage to the user or his/her possession.
.
Trouble Reason Solution
The unit doesn’t
work
No power supply Power-on and turn on the unit.
Water-full indicator illuminate Drain out the inner stored water
Timer function is active Cancel Timer function
Room temperature too low or too
high?
Suggesting ambient temperature between 7-40
℃
The unit does not
seem to perform.
In direct sunlight Draw the curtains
Windows or doors open, many
people or a heat source in the room Close windows and turn on another local air
conditioner
Filter is very dirty Clean or change the air filter
Air inlet or air outlet is blocked Clear out the stemming
Room temperature is lower than
setting temperature
Change the setting temperature
The unit noise is
high
The unit is not put on flat place Put the unit on flat and hard place( reduce noise)
Compressor
doesn’t work
Heat-exceeded protection is
active
Re-start the unit 3 minutes later till the temperature
low down.