KlikAanKlikUit Trust SMART Home ZTHS-100, Руководство пользователя

Страница: 3 / 4

4 5
ZTSH-100 TEMPERATURE AND HUMIDITY SENSOR EN EN ZTSH-100 TEMPERATURE AND HUMIDITY SENSOR
COMPATIBILITY
The Temperature and Humidity sensor works with the Z1 ZigBee
Bridge and the ICS-2000. NOTE: For receiving push notifications, a
fully working internet connection is required.
1. (RE)PLACE THE BATTERIES
A Remove the backplate by sliding it from the sensor.
B Hold the battery cover tightly and remove the battery pull strip
by pulling it from the sensor.
2. INDICATORS
The sensor contains a LED indicator to show the status of the
sensor. Please see below the meaning of the different LED
indications.
LED FUNCTION TABLE
Connection mode LED will flash fast for 1 min.
Connected successfully LED will light up for 3 sec (The App will also
indicate when the connection is successful)
Sensor reset LED will flash 6x
3. DOWNLOAD APP
To connect the sensor with a Z1
ZigBee bridge or ICS-2000, first
get the App by scanning the QR
code or go to trust.com/zigbee
and install it.
4. CONNECT SENSOR
A In the App, select a room,
press the + button and choose
Zigbee (Trust Smart Home)/
Temperature and Humidity
sensor and follow the
instructions. For manual set up
of push-notifications go to the
rules tab, press the + button
and select notification wizard.
5. MOUNT THE SENSOR
A
Remove the plastic layer
from the double sided-tape
on the back of the sensor
and place it on a flat service.
RESET SENSOR AND
ACTIVATE CONNECT MODE
Warning: This step will
disconnect the sensor from
the Z1 Zigbee Bridge or the ICS-
2000. To reset the sensor press
the button in the hole (with
the included pin) at the side for
approximately 5 sec with the
included pin. The LED will flash
6x to confirm the reset.
Activate connect mode: After
resetting the sensor you can
activate the connect mode by
pressing the button in the
hole on the side for approx.
2 sec. The LED will flash fast
for 1 minute to indicate the
connection mode.