There is an oil filling port on
the front side of the pruning
shears
.
Place the oil bottle in the lubricating
port. Hold the oil bottle up-right and
then lubricate.
The best oils to use are mineral oil or Canola oil, You can use them to
lubricateit.
Tightening Blade
For all the operations you must remove the battery from the pruning shears.
Check the blade tightening before use. A well tightened blade should not
move from left to right.
Adjust the tightness:
(1)
LoosenthelockingscrewusingtheAllenwrench""
.
(2) Using the hex socket wrench, make sure the tightening nut is hand tight
“ ". Do not over tighten.
(3) Tighten the locking screw using the Allen wrench " ".
(4) Check the tightness again using the above procedure.
9
8
O p e ra t e t h e p r u n e r s e v e ra l t i m e s , m a k e t h e l u b r i c a t i o n i s w e l l -
proportioned.
For blade replacement you must remove the pruning shears battery. The
replacement process is performed on the reverse side of the pruning shears.
(1)
UsetheAllenwrenchtoremovethetwocoverscrewsandremovethecover
(2)Use the Allen wrench to remove the locking screw" ".
(3)Again using the Allen wrench to remove locked screw nut" ".and remove
Anti-slide shim.
1
2
1
2
Replace Blade
1
2
3
1
1
2
3
( 4 ) Tu r n t h e r e v e r s e s i d e o f t h e
scissors and hit the blade (moving
blade) with a tool (Note:In order to
prevent the blade from loosening, the
blade will be difficult to remove)." "
R e m o v e t h e b l a d e , R e p l a c e t h e
blade" ".
4
4
5
(1)
(2)
(3)
1