K-Bot RX2/RX3
|
User Instructions
11
8. TROUBLESHOOTING
If the suggested solutions do not solve the problem contact your dealer
Problem
Solution
Pool Cleaner does not move 1. Check that the power supply is plugged in and turned ON and that the
cable is securely connected all the way into the side of the power supply.
2. Ensure the power outlet is functioning properly and that it has not tripped
the breaker in the fuse box.
3. Turn the power supply off. Wait 30 seconds then turn it back on.
4. Unplug the power supply. Open the impeller cover and check that nothing
is trapped in the impeller.
The Pool Cleaner moves but
does not clean the pool
1. Clean the filter bag.
2. After the Pool Cleaner starts moving observe it for several minutes and
make sure that it keeps moving. If it stops moving check the impeller and
the drive system to see if any debris is stuck there.
The Pool Cleaner cleans
only part of the pool
1. Check that there is enough slack in the cable for the Pool Cleaner to reach
all of the pool.
2. Clean the filter bag.
3. For K-Bot RX2 only: push in the float on the cable side (see figure
A
).
4. Check the brushes to see if they are obstructed or worn out.
The Pool Cleaner floats
instead of sitting on the
floor of the pool
1. Try removing the air again.
2. With the Pool Cleaner in the water squeeze the combined brush/Wonder
brush to make sure that they are completely water absorbent.
Cable has kinks
1. For K-Bot RX2 only: push in the float on the non-cable side (see figure
B
).
2. To remove the kinks stretch the cable out completely and let it sit for at
least a day in the sun.
The Pool Cleaner doesn’t
climb the walls
1. Clean the filter bag.
2. Check the level of the chemicals of the water. Improper levels may allow the
growth of algae making the walls slippery. If so, adjust the levels and scrub
the walls.
3. Check that the brushes aren’t worn out.
4. Check that the wall climbing mode hasn’t been cancelled via the remote
control unit (K-Bot RX3 only).
Click
Click
A
B
8151289–K-Bot_RX2-RX3_2012.indd 11
15/2/2012 10:00 AM
