To lower forks, pull lever to DOWN position (upper part of the slot).
To freely move the handle, set the lever in NEUTRAL (center notch of the slot).
TO LIFT A LOAD:
1.
Lower forks to lowest position.
2.
Insert forks under load or into pallet.
3.
Place lever in UP position (bottom part of the slot).
4.
Move handles up and down until forks reach desired height.
TO MOVE A LOAD:
1.
Place lever in NEUTRAL position (center notch of the slot).
2.
Pull or push to desired location.
TO LOWER A LOAD:
1.
Pull lever to the DOWN position (upper part of the slot).
2.
Pull forks away from load.
TECHNICAL PARAMETERS
Model No.
MN705
Capacity
4400 lbs
1995 kg
H - Maximum
Raised Height
7 11/16"
195 mm
S - Lowered Height
3"
75 mm
L - Fork Length
44 1/2"
1130 mm
E - Fork Width
6 3/4"
170 mm
B - Fork Outside
Distance
27"
685 mm
Dimensions of the
steer wheel
6" x 2"
152 mm x 50 mm
Dimensions of the
load wheel
2 3/4" x 3 1/8"
70 mm x 80 mm
99
99
330
420
1193
MAINTENANCE
LUBRICATION
Your KLETON pallet truck is equipped with grease fittings in order to facilitate greasing its bearings.
It is recommended to apply grease every 6 months.
Adding Oil (if required)
1.
Lower the pallet truck forks to their lowest point using the up/down lever on the handle. You will notice that the piston is now completely inside the pump assembly.
2.
Remove the oil reservoir plug (part #20 of the pump assembly).
3.
Using an oil can, add the hydraulic oil. The oil level should be up to the bottom of the hydraulic oil reservoir’s fill hole.
4.
Re-insert the oil reservoir plug (part #20 of the pump assembly).
5.
Pull the lever on the handle upwards to put it in the DOWN position (see page 3 for details).
Then, pump the handle up and down a minimum of 10 times in order to remove any air bubbles in the system.
Note:
Unless the pump is leaking, you should not have to add any additional oil. Please contact your KLETON distributor if your pallet truck is leaking.
5
