WARNING!
• Read and understand the entire operator’s manual before using the pallet truck.
• Don’t load pallet truck beyond rated capacity of 5,500 lbs.
• Secure load before transporting.
• Keep the load centered on the pallet.
• Don’t operate loaded pallet truck on ramps or inclines.
• Always wear appropriate safety shoes.
• Never leave a loaded pallet truck unattended in the raised position;
always lower load to the floor.
PALLET TRUCK ASSEMBLY
Note:
Individual trucks are assembled and ready to use. Pallet trucks purchased in
crate quantities (6 units to a crate) require some assembly.
Tools needed for assembly:
hammer, flat screwdriver, 14mm wrench
*** IMPORTANT - SAFETY ***
Verify that spring safety pin is in place.
The pin should be well rested in the
holes situated on each side of the pump
housing. If the safety pin is not rested
properly in one of the holes, put pres-
sure on the spring using a “C" clamp
pushing down on the pump stem. Once
pressure is relieved on the pin, reinsert
properly and remove clamp slowly,
To attach handle assembly to the frame:
If handle pin’s center hole is
facing away from you, insert pin
from other side.
*** IMPORTANT - FACT ***
The up/down lever’s chain
passes through this center hole.
If left this way, the chain will
have an “S" form and be under
too much tension, making the
up/down lever difficult to use
accurately.
1.
Insert handle pin without the
handle and verify that the center
hole is facing you.
3.
4.
Insert handle pin into cor-
responding holes and using a
hammer, drive in one spring pin
on one side only.
2.
