Klemsan Klecard, Руководство пользователя

Страница: 10 / 16

18 19
Klemsan Klemsan
Intensity / Darkness Control
The Klecard printer can operate in a large range of room temperature.
The sensor on the printhead detects the room temperature and optimizes the parameters to the default setting level.
Despite this, should be required to change the intensity level into the driver to get a better printing quality when the
room is too hot or too cold.
When ambient temperature is too hot, the ribbon could stick onto the media. This could affect the ribbon tension and,
in general, the quality level on the media. In this case you need to reduce the intensity level.
When ambient temperature is too cold, the ribbon does not stick the label but the darkness level of the print could
be weak.
This occurs also when the media are too cold even the room temperature level is acceptable. In this case you need
to increase the intensity level.
Setting the Intensity
After installing the printer, go to the Klecard TPC printer properties section
in the Control Panel \ Devices and Printers of your computer, and change
the Darkness Control option on the device settings to By Software .
P.S.: After this feature is activated, you can instantly determine the printing
intensity specific to each label type with Klemark Pro software.
When the printer is used continuously, the thermal head temperature of
the printer increases.
Therefore, if you are printing many projects consecutively with a constant print intensity, you will need to reduce this
intensity after a while.
You may notice this change when the ribbon starts sticking to the label.
IMPORTANT
Maintenance of the Klecard
Cleaning the Exterior
Wipe the exterior of the printer with a dry cloth frequently.
Cleaning the Printhead
Clean the printhead at every ribbon change, or more often if streaks start appearing or the ribbon has torn.
Always clean the thermal head with an IPA (isopropyl alcohol).
Please pay attention during the cleaning process.
1 - Move out the tray (if it is inside) by pressing the Function Button.
2 - Turn off the printer by pressing the On/Off Button for two second.
3 - Remove the top plastic cover.
4 - Remove the marking plate from the tray.
The tray should be out as
shown.