TJXTREME
Installation and Operation Manual
PG 29/36
REV: A (5/8/2020)
9.8.
Final Trumpet Installation
9.8.1.
Re-attach Trumpets to Air Horn Drivers, as shown below. Ensure Trumpets are firmly tightened by
grasping Metal/Chrome Collar, as performed earlier.
9.8.2.
Reposition Air Horn Drivers if needed
to ensure at least 1/4” of space exists between them and vehicle
,
especially any moving parts such as Brake Cables, Lines, Wiring, etc.
Final torque fasteners to 75 in-lbs
.
Figure 18
–
Re-attaching Trumpets, Exploded View (No Air Tubing Shown)
9.9.
Install 1302 Remote Connect Coupler to Vehicle
9.9.1.
Remove Quick Connect Coupler & Rubber Cover from
9.9.2.
Decide where on vehicle to install Coupler. Some installers choose to directly fasten Coupler to supplied
Brackets by using self-tapping screws or drilling a hole for Coupler itself.
NOTE:
modification of Brackets in any way voids their warranty.
9.9.3.
Use supplied
#F10 Air Tubing, Bracket, Fittings, and Hardware
and attach Tubing to port shown in
. Some example locations include under hood, on, or below front/rear bumper, etc.
Figure 19
–
Example of Air Coupler Mounted to Bumper
End of Section
FRONT
SHORT
LONG
75 in-lbs
