OPERATION
4. Empty recovery tank every time water is added to
on tank.
leaning, relieve water pressure from tool
isconnecting hose. Squeeze trigger for
econds after turning switches off.
E OPERATION-DRY CLEANING
soluti
5. After c
before d
five s
MACHIN
PRE-OPERATION AND HEATIN
32506 (11-98)
9
G
WARNING: Do not use OMS cleaning
sh point of less than 125° F.
Always set up each job with all of the following
s satisfied (Figure 7).
in place.
o vacuum and
an air mover inside room being
rs.
08° F heater button.
Whenever heater comes on it will automatically
come on in the low 120° F setting regardless of
where it was set the last time it was used.
Confirm low heat range by observing green light
on.
5. Always wear a respirator.
solutions with a fla
condition
1. Be certain both lids are
2. Always connect exhaust hose t
vent outdoors.
3. Always place
cleaned and near machine to disperse vapo
4. Never press the red 2
Warning: Do not proceed to clean unless
all five conditions are met.
6. Turn on pump and be certain it is primed.
7. Turn on heater in the 120° F setting.
ANING
CLE
1. Turn on vacuum (assuming pump and heater is
on).
holstery or drapery tool in hand and
moving the tool in
rward and backward strokes over the
OPERATION – FLUSHING
already
2. Take up
squeeze valve trigger while
short fo
fabric.
MACHINE
Switching from
solutions may
wet to dry or dry to wet cleaning
cause a gel to form in the pump
ution in not taken. Follow the
changing solutions.
olution from solution tank and wipe
n tank with new fluid.
Oil and water do not mix!
vacuum lid in place and plug the
vacuum inlet with your hand. Plug the far end of
the solution hose into the solution line purge
connector located on the side of the recovery
tank (Figure 8).
4. Turn on vacuum and pump for 45 seconds.
5. Remove the hose from the side of the recovery
tank and connect to cleaning tool.
and hoses if preca
steps below when
1. Empty all s
dry.
2. Fill solutio
REMEMBER:
3. Secure the
Fig. 7
Fig. 8
1
2
3
4
5
