Kleenmaid ST GEORGE DW12I, Инструкция по эксплуатации

Страница: 6 / 18

• 7 •
Protection against water damage :
Your machine is equipped with systems that
protect you from flooding.
- Anti-overflowing mechanism. This system
activates the waste pump if the water level in
the tub reaches an abnormal level.
- Anti-leakage device. This system interrupts the
water supply if a leak is detected underneath
the machine.
If one of these mechanisms is started, contact
the after-sales service to put it back into
working order.
Your machine is equipped with a anti-bursting
pipe.
Evacuating waste water (Fig. 3)
Connect the waste pipe
A. Either to the ventilated siphon. The waste
pipe must be free in the siphon and should
be no deeper than 20 cm.
B. Or on the sink siphon. Be careful not to
forget to remove the siphon cover.
Be careful to fix the waste pipe down with a tie
to avoid any flooding. In any case, the end of
the pipe must be between 60 cm and 1 m high.
Avoid folding the pipe when installing.
- Horizontal drain lines should not exceed 5 m
length.
- Ensure that the drain hose is fully extended
and not restricted in any way.
NOTE : Do not connect drain hose directly to a
waste disposal unit as blocking with food
waste will occur.
Connecting to the power supply :
You should use an earthed plug to connect to
the power supply. In case of a direct connection,
the main switch terminal should be at least
3 mm apart.
The electric plug should remain accessible. Do
not use an extension lead or multiple plug.
• We cannot be held responsible for any
incident caused by the machine being badly
earthed.
In any case, the machine must be fitted in
compliance with the applicable regulations in
your state as well as any extra instructions from
the Electricity Company. The machine’s approval
and model are indicated on the sticker fixed to
the left-hand side of the door. The machine
must be turned off when connecting to the
electric circuit.
Replacing the electric lead
WARNING : In the interests of safety, the
electrical supply lead should ONLY be replaced by
the manufacturer’s after-sales staff or a similarly
qualified person.
Rinse aid is necessary as it avoids stains on the
dishes and makes drying easier.
IMPORTANT ! Only use products intended for
dishes and NOT detergents intended for hand
washing !
We recommend using Kleenmaid Dishwasher
Rinse Aid. Please phone our After Sales Service
on 1 300 652 100 for the Store nearest you.
Filling and adjusting the rinse aid container
(Fig. 5-6) :
Put the door in a horizontal position when
filling the container and unscrew the cap in the
door counter clockwise.
Fill to just below the adjusting lever.
If the product overflows on filling, remove the
excess with a sponge to avoid any foam
forming.
If you experience stains or bad drying after
several cycles, you may adjust the dosage using
the selector :
Soft water : level 1 to reduce the dose
Hard water : level 3 to increase it.
Finding the level of the rinse aid :
A light on the control panel comes on when
you need to add rinse aid.
For child safety :
Dishwashing detergent and rinse aid should be
treated as poisons and stored where they are
not accessible to children.
ADDING RINSE AID
INSTALLATION CONTINUED