Kleenmaid SPOT120, Инструкция по использованию и гарантийные обязательства, Страница: 8 / 12

5
Description of the Rangehood - Fig. 1
1 Control panel
2 Grease filter
3 Grease filter release handle
4 lamp
5 Vapour screen
6 Telescopic chimney
7 Air outlet (used for filter version only)
Operation –
All Rangehood versions
Use the high suction speed in cases of concentrated kitchen
vapours. It is recommended that the rangehood suction is switched
on for 5 minutes prior to cooking and to leave in operation during
cooking and for another 15 minutes approximately after terminating
cooking.
Operation –
Model with button panel
A. on/off light switch
B. on/off aspiration switch and minimum power selection
B+C. medium power selection aspiration switch
B+D. maximum power selection aspiration switch
Operation –
A B C D
Maintenance
Prior to any maintenance operation ensure that the rangehood is
disconnected from the power supply.
Cleaning
The rangehood should be cleaned regularly internally and externally.
For cleaning use a cloth moistened with denatured alcohol or neutral
liquid detergents. Avoid abrasive detergents.
Warning:
Failure to carry out the basic standards of the cleaning of the
rangehood and replacement of the filters may cause fire risks.
Therefore we recommend observing these instructions.
Grease filter
This must be cleaned once a month using non aggressive
detergents, either by hand or in the dishwasher, which must be set
to a low temperature and a short cycle.
When washed in the dishwasher, the grease filter may discolour
slightly, but this does not affect its filtering capacity.
To remove the grease filter, pull the spring release handle "F" - (Fig.
2).
Charcoal filter (filter version only)
It absorbs unpleasant odours caused by cooking.
The charcoal filter can be washed once every two months
using hot water and a suitable detergent or in the dishwasher
65°C (if the dishwasher is used, select the full cycle function and
leave all dishes out). Eliminate excess water without damaging the
filter, then remove the mattress located inside the plastic frame and
put it in the oven for 10 minutes 100° C to dry completely. Replace
the mattress every 3 years or when the cloth is damaged.
Remove the filter holder frame by turning the knobs "G" 90° that affix
the chimney to the rangehood (Fig. 3).
Insert the pad "I" of activated carbon into the frame "H" and fit the
whole back into its housing "J".
Replacing lamps - Fig. 4
Warning!
Prior to touching the light bulbs ensure they are cooled down.
1. Extract the guard by levering it off with a small screwdriver or
similar tool.(fig. 4).
2. Replace the damaged light bulb.
Only use halogen bulbs of 20W max, making sure you do
not touch them with your hands.
3. Close the lamp cover (it will snap shut).
If the lights do not work, make sure that the lamps are fitted
properly into their housings before you call for technical
assistance.
Caution
This appliance is designed to be operated by adults. Children should
not be allowed to tamper with the controls or play with the appliance.
Do not use the rangehood where the grill is not correctly fixed! The
suctioned air must not be conveyed in the same channel used for
fumes discharged by appliances powered by anything other than
electricity. The environment must always be adequately aerated
when the rangehood and other appliances powered by anything
other than electricity are used at the same time. Flambé cooking
with a rangehood is prohibited. The use of a free flame is damaging
to the filters and may cause fire accidents, therefore free flame
cooking must be avoided. Frying of foods must be kept under close
control in order to avoid overheated oil catching fire. Carry
out fumes discharging in accordance with the regulations in force
by local laws for safety and technical restrictions.
WARNING!
The appliance is not intended for use by young children or infirm
persons without supervision.