Kleenmaid RH4X, Инструкция по использованию и гарантийные обязательства

Страница: 6 / 12

6
Introduction to the Rangehood -
Fig. 1.1
1.
Light Switch
2.
Motor Speed Switch
3.
Illumination of the cooking surface
4.
Grease Filters/grease filter support
grate
5.
Light Cover Supports
6.
Pull-Out Drawer
Metal Filters
Removing the Grease Filters
a.
Remove the pull-out drawer
completely.
b.
Press the side handles (Fig. 2.3)
towards the opposite side and
remove the filters.
Putting the Filters Back in Place
a.
Remove the pull-out drawer
completely and mount the grease
filter so that it covers the drawer.
b.
Close the drawer and install the
remaining grease filter.
Opening the Light Cover Support
a.
Remove the pull-out drawer
completely.
b.
Move the hook locks (Fig 1.2) as
indicated by the arrows and
completely remove the lamp from the
housing (Fig. 1.3).
Systems Available
Venting Outdoors
The air is vented outdoors through a duct
which must be connected to the exhaust
opening
K
(Fig. 5) by means of the flange
H
. The diameter of the exhaust duct must
be exactly the same as that of the flange
– 12
0mm.
Air Recirculation
— The air is cleaned by means of
charcoal filters and then circulated
back into the room.
— The use of a charcoal filter is
necessary when the rangehood
cannot vented outdoors either
because ducting is not available or
cannot be installed.
— The filtered air is returned from atop
the cabinet through a duct that
passes through the cabinet itself.
The diameter of the duct must be the
same as that of flange
H
(Fig. 5).
The deflector
J
can be fixed to the
outlet hole using the two screws
provided (Fig. 4).
To fit or replace a carbon filter:
a.
Request a charcoal filter from the
retailer, specifying the model and
type of rangehood.
Caution! Some charcoal filters come
covered with a plastic film to protect
their filtering properties. If this is the
case, remove the film before
installing the filter.
b.
Remove the pull-out drawer
completely.
c.
Remove the grease filters or the
grates.
d.
Place the activated carbon filter in
position. To assemble the filter,
insert it in its seating and fix it in
position using the clips (Fig. 7)
e.
Remove the grease filters or grills.
To remove the carbon filter, follow the
procedure described above in the reverse
order.
Installation
When installed, the distance between the
rangehood and cooktop must be at least
650mm from gas, electric or mixed
cooktops. Please confirm these
measurements with your local gas,
electrical and building authority.
Caution
This appliance is designed to be operated
by adults. Children should not be allowed
to tamper with the controls or play with
the appliance. Do not use the rangehood
where the grill is not correctly fixed! The
suctioned air must not be conveyed in the
same channel used for fumes discharged
by appliances powered by other than
electricity. The environment must always