Kleenmaid OCCPB, Инструкция по эксплуатации и сборке, Страница: 12 / 30

A S S E M B L Y
12 12
TEST FOR LEAKS WITH A
SOAP SOLUTION, NEVER WITH AN
OPEN FLAME (Refer to pages 4 and 5).
CONNECTING TO, AND DISCONNECTING
FROM GAS SOURCE – propane model
CONNECTING TO GAS SOURCE
1. Place the gas cylinder into the gas cylinder tray and face
the gas cylinder valve to the left front corner. Secure with
the wing bolt.
2. Attach cylinder connection
device of regulator and hose
assembly to cylinder
valve outlet.
Tighten firmly.
3. Open the gas
cylinder valve fully
to allow gas to flow.
4. Leak test all accessible
connections thoroughly
using a soapy water
solution prior to lighting the barbecue.
Refer to Safety information, pages 4 and 5.
5. If a leak is found, turn gas cylinder valve off and do not use
barbecue until repairs or replacement can be made.
DISCONNECTING FROM GAS SOURCE
1. Turn the burner control
‘OFF’
.
2. Turn the gas cylinder valve off fully.
3. Detach the regulator assembly from gas cylinder valve.
IMPORTANT: Before connecting and disconnecting
barbecue to gas source, ensure burner controls are
in ‘OFF’ position.
NOTE: The ‘OFF’ position on the control panel is
identified by either a small black dot, a short vertical
black line, or the word ‘OFF’.
When the marking, or the word ‘OFF’ printed on
the control knob, aligns with the printed marking on
the control panel, then the burner is in the fully off
position.
CAUTION: When the appliance is not in use, the gas
must be turned off at the gas cylinder
.
Familiarise yourself with the general information and safety guide-
lines located at the front of this booklet. Check to see that gas
cylinder is filled and that end of each burner tube is properly
located over each valve orifice. Set burner controls to
‘OFF’
position.
ENSURING BURNER CONTROLS ARE OFF
Direction for
tightening
Gas
cylinder
Gas cylinder
pull-out tray
Cylinder valve
outlet
Unscrew igniter cap from control panel. Place supplied AA battery
into the igniter slot with positive pole facing you. Position the cap
and spring over the AA battery and tighten onto control panel.
INSTALL IGNITER BATTERY
Spring
AA battery
Igniter slot
Igniter
cap
Barbecues for use on natural gas must be installed by an
authorised person. This appliance is not readily converted from
propane to natural gas. Natural gas units are factory assembled.
NATURAL GAS INSTALLATION
1. Connect a manometer to the test point located at the
manifold connection.
2. Light all burners and set at maximum rate.
Refer to page 14
for lighting instructions.
3. Adjust the regulator to an operation pressure of 0.95 kPa.
SETTING APPLIANCE TEST POINT PRESSURE