Kleenmaid KCRHSCK90, Инструкция по использованию и гарантийные обязательства

Страница: 6 / 20

2. Install a roof or wall cap. Connect a 150mm round metal duct to the cap
and work backwards toward the hood. Ensure joints are completely sealed
with duct tape.
1. Plan where the ductwork will run between the hood and the outside.
The hoods exhaust vertically but can be ducted to the rear behind the
chimney duct through an outside wall or vertically up through the ceiling
to the roof. A short straight duct run will produce the most air flow.
Length and elbows will reduce the efficiency of the blower.
1. Before mounting the hood, plug in and test all functions for proper operation.
2. Removed the filters from the bottom of the hood to prevent damage during
the installation.
3. With assistance, hold the hood temporarily in position ensuring the bottom is
above the minimum clearance for the cooking surface. Mark on the wall the
holes for the two mounting screws.
4. Drill the holes (A) at the distances indicated. Use the appropriate screws and
screw anchors for your wall type (e.g. reinforced concrete, drywall, etc.).
If necessary, prepare back wall with cross framing for secure installation.
5. Mount the hood on the wall screws. Align it in a horizontal position relative to
cabinets. When the hood has been adjusted, secure unit by tightening screws (A).
6. Connect a 150mm aluminum duct tube (not included) to the exhaust piece using
duct tape on all seals. (C)
1. Carefully loosen but do not separate the telescopic chimney duct pieces.
2. Arrange the electrical power supply within the dimensions of the decorative
chimney duct.
3. Adjust the width of the support bracket to match the upper duct. Fix it to the
ceiling using the screws (B) so that it is centered in line with your hood and
at a distance from the ceiling indicated.
Fixing the Decorative Chimney
Flue
Installing the Ductwork
Fixing to the Wall