6
37005
Installing the Washer . . .
Positioning and
Levelling the Washer
Place rubber feet on all four
levelling legs.
Place washer in position on a
clean, dry, and reasonably firm
floor. Installing the washer on any
type of carpeting is not
recommended.
Loosen locknuts and adjust the
two front levelling legs. Once
adjusted, tilt the unit forward on
front legs and lower back down
into position to set the rear self-
levelling legs.
Washer must not rock. After
washer is at desired height,
tighten locknuts securely against
bottom of washer base. If these
lockntus are not tight, washer will
not remain stationary during
operation.
Improper installation or flexing of
a weak floor will cause excessive
vibration.
Do not slide washer across floor
once the levelling legs have been
extended, as legs and base could
become damaged.
Shipping Brace
The shipping brace should be
saved and must be used (to
prevent damage to washer
components), whenever washer is
moved or transported to a new
location.
Motor Overload Protector . . .
The internal overload protector
will stop the motor automatically
in the event of an overload. The
overload protector will reset itself
in two or three minutes and the
motor will restart automatically. If
the overload protector stops
motor again, remove the washer
from use and call the serviceman
to correct the problem.
LEVELLING
LEG
W179IE2C
LOCKNUT
LEVEL
RUBBER
CUP
WASHER
BASE
