• 5 •
• 4 •
INSTALLATION
Please read the instructions in this booklet
carefully. You will find instructions necessary for
security, installation and using your machine as
well as the guarantees. We advise you to keep
the booklet and pass it on if you sell the
machine.
We cannot accept responsibility if the
instructions below are not followed :
- Please destroy the packaging in an
appropriate way and in compliance with
environmental protection legislation.
- If the machine is visibly damaged, do not
connect it and contact your dealer.
- It should be placed in a frost-free area. In case
of frost, the hydraulic systems may be
damaged.
- The water supply and evacuation pipes must
be connected according to instructions.
Incorrect connections may cause damage.
- To ensure proper stability, built-in machines
should be installed below a continuous work
surface fixed to the adjoining cabinets.
- You should not stand or lean on the open
dishwasher door. The machine could tip over
or be damaged.
- The machine is intended to wash dishes and
should not be put to other uses.
- Using solvents to clean or maintain your
machine is highly unsuitable.
You should store dishwasher products as well as
other cleaning products out of the reach of
children. These products have a corrosive effect
on the mouth and pharynx if they are
swallowed.
- If the machine malfunctions due to other
causes than those mentioned in this booklet,
disconnect the machine (remove the plug) or
break the circuit concerned and contact our
after-sales service.
- The machine complies with applicable safety
regulations. Any repairs should only be carried
out by qualified technicians. Repairs or
changes that do not conform may be
dangerous for the user. In case of replacement,
only use original parts.
- Broken machines should be taken to the
closest recycling centre. Destroy the door
closing system so it no longer works (children
may close themselves in whilst playing and
suffocate). Cut the electric cable after having
removed the plug from the socket.
- You are strongly advised to disconnect the
machine after use and turn off the water
supply.
- Do not let children play with the machine or
touch it.
- The water inside the machine is not suitable
for drinking.
- When the machine is running, do not open
the door. This may provoke steam leakage or
splattering of water.
SAFETY ADVICE
This appliance is not intended for use by young
children or infirm persons unless they have been
adequately supervised by a responsible person
to ensure that they can use the appliance safely.
Dishwasher detergents are strongly alkaline.
They can be extremely dangerous if swallowed.
Avoid contact with the skin and eyes and keep
children away from the dishwasher when the
door is open. Check that the detergent
receptacle is empty after completion of wash
cycle
Plumbing :
1 . Water Connection
• This Kleenmaid “Super Silent System”
Dishwasher can be connected to cold water or
hot water not exceeding 65 °C.
• We recommend that the Dishwasher is
connected to a cold water supply.
NOTE : Connection to a hot water supply will
change the length of the wash cycles
and can reduce the drying efficiency of
the dishwasher.
2 . Water Supply (Fig. 2)
a . The water supply to the Dishwasher should
not be less than 12 mm domestic water pipe.
A readily accessible tap must be installed in
the supply pipe.
b . The inlet connection hose supplied is fitted
to a 3/4" BSP male thread, which must have
an adequate sealing face for the washers
supplied.
c . If the Dishwasher is connected to a hot water
supply, then the water temperature at the
Dishwasher must never exceed 65 °C.
d . The water supply pressure is to be between
0.2 MPa (3.0 psi) minimum and 0.7 MPa
(100 psi) maximum.
If pressure is greater 100 psi, it is recommended
to fit a pressure limiting valve to prevent
damage from rises and increased pressure of
peak demand.
IMPORTANT ! :KLEENMAID RECOMMENDS THAT
YOUR DISHWASHER BE INSTALLED BY AN
AUTHORISED Kleenmaid INSTALLER OR SERVICE
AGENT !!
Before you start :
1 . These instructions are intended as a guide
only. It is the responsibility of the Plumber
and Electrician to ensure that each
installation complies with local by-laws.
2 . Connection to cold water is recommended.
3 . This Dishwasher must not be connected to a
water supply where the temperature of the
water exceeds 65 °C. If this Dishwasher is to
be connected to a system where there is no
temperature control, a temperature control
valve, limiting the water temperature must
be fitted.
4 . When installing the Dishwasher, check that
the drain hose does not become restricted or
kinked.
Levelling : Adjusting the feet :
Make sure that the machine is properly upright
and stable. The four feet may be altered, adjust
them if necessary using a wrench or a
screwdriver. Badly adjusted feet may move the
door off centre and make the machine unstable.
IMPORTANT : Do not connect the dishwasher to
the power or water supply before completing
installation.
If you are installing your dishwasher on carpet,
adjust the feet so that you leave space for air to
circulate underneath the machine.
Fitting your machine into your kitchen :
The building in sizes for the machine are given
in the “technical characteristics” chapter on
page 15.
Glue the steam protector supplied with your
machine underneath your worktop.
To maintain stability and proper alignment, you
should attach your machine to the work surface
using a bracket.
.
Содержание DW21 X
Страница 9: ......
