Kleenmaid DW15W, Инструкция по использованию и гарантийные обязательства

Страница: 11 / 18

• 11 •
Voltage : 230-240 V – 50 Hz – Fuses : 10 A
Power : 2150-2300 W
Capacity : 14 place settings Water pressure : 3 psi/21 kPa min
100 psi/690 kPa max
Water evacuation pipe height : 60 cm - 1 m
TECHNICAL CHARACTERISTICS
INSTALLATION
COMPARATIVE TESTS ACCORDING TO : AS/NZS 2007 : 98
Programme “2 + Eco Wash 50 °C ”
• Rinse aid dispenser setting on : 3
• Quantity of washing product : 40 g.
• For the determination of Drying Index the door of the dishwasher was opened approximately
240 mm at the end of the programme for 30 minutes.
Building the free-standing machine in
If you install the dishwasher built-in under an existing worktop, you must attach it with the front
bracket to a fixed worktop . If installing in this way, proceed as follows:
- Remove the worktop by unscrewing the 2 screws under the edge of the upper plate.
- Fit the dishwasher into its housing.
- Adjust the height of the feet if necessary (fig. 4).
- Use two screws to fasten the front bracket to the kitchen worktop, so as to make your dishwasher
fast.
For safety reasons Kleenmaid recommends that your dishwasher is not installed directly
below a cooktop. If installation is carried out in this manner your warranty may be void.
NOTE :
These measurements are
shown without worktop fitted. If installing
with worktop fitted :
1 - To over all height add 32mm
2 - To overall width add 4mm
3 - Overall depth of worktop from rear
to front comers = 581mm
4 - Overall depth of worktop from rear
to centre front 600mm