SpeCifiCaTionS
Models 23 and 25
CustomStyle
TM
Side-by-Side fridge
*Technical Specifications and product sizes can be varied by Manufacturer without notice. Any cut-outs for appliances should only be by physical measurements. Drawings are not to
scale. All information supplied is for general reference purposes only and is on the understanding that Kleenmaid Pty Ltd will not be liable for any loss, liability or damage whatsoever
arising as a result of reliance of such information.
Side-by-Side Fridge
Models 23 and 25
CustomStyle™
For your nearest store call 13 13 08
www.kleenmaid.com.au
EXCLUSIVE TO
BEFORE YOU BEGIN
*
Installation of power and water outlets; if located in fridge cavity, please ensure they are above fridge height.
Instructions to your plumber: Install 1/2 inch stop cock (tap), located in the cabinetry or adjacent to, or if possible above fridge cavity. Not to be
located in the fridge cavity.
The water line installation is not warranted by the refrigerator or icemaker manufacturer. Follow these recommendations carefully to minimise the
risk of expensive water damage.
Water hammer (water banging in the pipes) in house plumbing can cause damage to refrigerator parts and lead to water leakage or flooding. Call
a qualified plumber to correct water hammer before installing the water supply line to the refrigerator.
To prevent burns and product damage, do not hook up the water line to the hot water line.
If you use your refrigerator before connecting the water line, make sure the icemaker power switch is in the
O (off)
position.
Do not install the icemaker tubing in areas where temperatures fall below freezing.
When using any electrical device (such as a power drill) during installation, be sure the device is insulated or wired in a
manner to prevent the hazard of electric shock.
All installations must be in accordance with local plumbing code requirements. Installation of the icemaker must be done by a qualified service
technician.
!
WARNING! Connect to potable water supply only.
INSTALLING THE WATER LINE
DIMENSIONS AND SPECIFICATIONS (for CustomStyle™ and installed trim models)
CM
#ABINET
7ATER
%LECTRICAL
MM!IRSPACE
MM'APMM
7ALL0LATES
CM
#OUNTERTOP
/ÊLiÊViVÌi`Ê>LÛiÊvÀ`}iÊ i} Ì
Dimensions
PIE23
PJE25
A-
Height to top of Hinge
1759 mm 1832 mm
B-
Height to top of case
1747 mm 1817 mm
Height to top of door trim
1785 mm 1840 mm
C-
Case depth without door
607 mm
607 mm
D-
Case depth without
door handle
680 mm
689 mm
E-
Case depth with door
handle
720 mm
751 mm
F-
Depth w/FF door open 90°
1158 mm 1169 mm
G-
Width
908 mm
909 mm
H-
Width w/door open 90°
w/door handle
1016 mm
970 mm
Air Clearances
Allow the following clearances from cabinet for ease of
installation, proper air circulation and plumbing and
electrical connections:
Sides
4 mm
4 mm
Top
25 mm
25 mm
Back
13 mm
25mm
A
B
C
D
E
F
G
H
PIE23_PJE23_specs.indd 1
14/2/08 11:24:32 AM
pie23_pje25_specs.indd 2
17/9/08 11:37:38 AM
