14
CH311S SOLID ELEMENT – INSTALLATION INSTRUCTIONS
INSTALLATION
These instructions are intended to be used by a qualified installer, who will be responsible for the
installation, adjustment and maintenance according to the current Australian standards.
All operations must always be carried out with the equipment disconnected from the electricity.
POSITIONING
The appliance can be fitted into a working area as illustrated on the figure. Apply the seal supplied over
the whole perimeter of the working area.
ELECTRICAL CONNECTION
Prior to carrying out the electrical connection, please ensure that:
•
The cooktop characteristics are such as to follow what is indicated on the rating plate applied to the
bottom of the work-top.
•
The cooktop is fitted with an efficient earth connection, following the current standards and law
provisions in force. The earth connection is compulsory in terms of the law.
Should there be no cable and/or plug on the product, If not use a suitable absorption material for the
working temperature as well, as indicated on the rating plate. Under no circumstance must the cable
reach a temperature above 50
°
C of the ambient temperature.
Should a direct connection to the network be required, it will be necessary to interpose an omnipolar
switch with minimum aperture between the 3 mm. contacts, dimensional to bear the plate load and it
must follow the standards in force (the yellow/green earth cable must not be interrupted by the switch).
The plug or omnipolar switch must be easily reached on the installed equipment.
NOTE:
The manufacturer declines any responsibility in the case where the above and the normal
accident prevention regulations have not been respected.
Side view
Front view