1. LOW INPUT: (1)
The input jack will accept signals from low impedance guitar pickups, Be sure to
use a high-quality shielded cable to connect the guitar to the amplifier.
2. High INPUT: (2)
The input jack will accept signals from high impedance guitar pickups, Be sure to
use a high-quality shielded cable to connect the guitar to the amplifier.
3. Gain (3)
Preamp Gain levels control
4. Tones: (4)
Tones level control
5. VOLUME
:
(5)
Volume controls. The final level adjustment should be made after the desired
sound has been achieved
6. STANBY
:
(6)
7.POWER
:
(7)
8. POWER SOCKET (8)
9.PENTODE /TRIODE SW (9)
5w/2.5w power switch
10. XLR DI
:
(10).
XLR DI out for recording.
11. OUTPUT: (11)
Provide for connection of external 4ohms speaker cabinet.
12. OUTPUT
:
(12)
Provide for connection of external 8ohms speaker cabinet.
SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
POWER AMPLIFIER SECTION
6L6’s with 12AX7 driver
Rated Power &Load
5w RMS into 8, 4 ohms
Power @Clipping(Typically)
(5%THD,1KHZ,120vAC line) 5W RMS into 8 ,4ohms(Bias must be reduced to
measure)
Frequency Response:
+0,-2db,50HZ to 15KHZ,@, 20w RMS into 16 ohms
Hum &Noise:
