26
EN
•
Clean the ice storage bin once weekly.
• Open the ice maker door and remove all the ice cubes.
• Use a mild detergent to clean the inner wall of the ice storage bin and rinse with
water.
• Wipe the inner wall with a cloth dampened with a mild detergent, rinse with water,
and finally wipe the inner surface with another piece of clean cloth.
Inlet valve cleaning
•
Unplug the power plug or disconnect the power supply and turn off the faucet.
• Unscrew the inlet pipe and water valve connections.
•
Gently pull out the filter on the inlet valve by hand.
•
Brush the filter with a brush and rinse with water.
•
Put the filter back into the water valve, then connect the inlet pipe, open the faucet
and check for water leakage.
TROUBLESHOOTING
Fault
Inspection
Cause
Solution
Ice maker is
unable to start.
Power switch
In the OFF
position
Turn the power
switch to the ON
position.
Power plug
Not plugged into
the socket
Plug the mains
plug into the
socket.
Control panel fuse
Faulty or
damaged
Check and
replace
Ice storage bin
The ice storage
bin is full and the
ice is pressed
against the blades
of the evaporator.
Remove the ice
or remove the ice
from the blades of
the evaporator.
Power supply
No electricity or
voltage is too low
Contact your
electricity supplier.
Wasserhahn
No water or
water pressure is
too low
Increase the water
pressure.
Inlet valve
The filter is
clogged or the
water valve is
faulty.
Clean the filter or
replace the inlet
valve.
