Klarstein 10032336, Инструкция по эксплуатации

Страница: 16 / 44

16
EN
SLEEP Mode
The “Sleep Wind“ allows you to set the product so that the speed will decrease
gradually from a high speed to low (depending on the original fan speed selected by
the user). The preset programming for each setting is as follows:
• If it is selected HIGH, the unit will work under HIGH NORMAL wind mode for half
an hour, then revert to work under MID NORMAL wind mode for half an hour and
then revert to LOW NORMAL wind mode.
• If it is selected MID, the unit will work under MID NORMAL wind mode for half an
hour and then revert to LOW NORMAL wind mode.
• If it is selected LOW, the unit will work under LOW NORMAL wind mode.
OSC Function
Press the “OSC” button, the vertical blades will swing automatically back and forth, and
the swing symbol LED light will light up; press the button again to switch off this function.
The horizontal blades can be adjusted by hand.
Timer Function
Press the “TIMER” button to limit the ON time from 1-8 hours. The LED display will light
up the digital.
Note: All the above mentioned modes and functions can be set using the supplied
remote control, the remote control requires one
battery CR2032 (included). Make
sure the poles are not reversed when you insert the batteries.
COOL Function
Press the COOL button to start the pump. Press the button again to stop the pump. If the
sensor detects a lack of water, it briefly stops the pump and then restarts it to eliminate
sensor failure. If he continues to register a lack of water, he stops the pump, an alarm
sounds and the COOL indicator goes off.
Drying Function
Press the “TIMER” button 3seconds, start to filter air drying, the pump stops working, it
works on HIGH speed for 20 minutes to stop working. When the filter drying, there is
only “ON/OFF” button can operate, others are invalid.