14
Troubleshooting
Problem
Possible Cause
Solution
symbol is lightening on
and the arrow flashes.
Lack of Water.
Stop the ice maker, fill water, and press “ON/OFF”
button again to restart the unit.
symbol is lightening
and letter “F” flashes.
There is too much ice.
Suggest you to obtain the ice-cube.
No ice cube inside.
Remove the probable obstacle inside or clean the
inside wall of the ice storage, if still can’t start to ice
making process, press “SELECT” for more than 5
seconds to run the ice making for 10 cycles at most.
Errorcode
Ambient temperature
sensor breakdown
The unit can still work, but suggest to call the ma-
nufacturer service man or electrical technician to
change to a new sensor.
Errorcode
The ice-making box can
not reset normally.
Call the manufacturer service man or qualified
technician to check the problem.
Ice cubes on the evapora-
tor stick together.
The ice cycle is too long.
Stop the ice maker, and restart it after the ice blocks
melt. Select the small size ice cube selection.
Water temperature in
inner tank is too low.
Change the water in the inner Tank. Temperature of
water is better set between 7，-32， .
There are ice-cube inside
the unit, but can’t dispen-
se the ice-cube when you
push the “ICE” button.
Moving shaft for the Ice-
cube is blocked.
Release the button for ice-cube for 3 seconds, then
again push the “ICE” button.
Ice making cycle is normal
but no ice is made.
Ambient temperature
or water temperature in
inner tank is too high.
Please run the ice maker below 32， and pour colder
water into tank.
Refrigerant liquid leakage. Verify by a qualified technician.
Pipe in the cooling sys-
tem is blocked.
Verify by a qualified technician.
