10
11
Installation
Before Using Your Wine Cooler
•
Remove the exterior and interior packing.
•
Before connecting the Wine Cooler to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
•
Clean the interior surface with lukewarm water with a soft cloth.
•
The cooler is specially designed for wine storage, please do not put in other goods.
Installation:
•
The cooler should be placed independently so as to make sure good heat dissipation. The back of
the cooler should be away from the wall 10cm at minimum.
•
Place your wine cooler on a fl oor that is strong enough to support it when it is fully loaded. To level
your Wine Cooler, adjust the front leveling leg at the bottom of the Wine Cooler.
•
Locate the Wine Cooler away from direct sunlight and sources of heat (stove, heater, radiator,
etc.).Direct sunlight may aff ect the acrylic coating and heat sources may increase electrical con-
sumption. Extreme cold ambient temperatures may also cause the unit not to perform properly.
• Avoid locating the unit in moist areas.
• Plug in the proper power socket. Make sure that the shape and voltage of the socket is consistent
with the nameplate on the back of the cooler.
Operation Instruction
4.1 Control Panel Below
(Single Zone):
•
Display Windows
· RUN light:
Indicator light of compressor working. While the compressor operating, the red light is
on. While it stops operating, the red light is off .
· SETTING:
Display of the temperature you set. The range of temperature setting is 0
℃
~37
℃
or 32
℉
~99
℉
.
· CHAMBER:
Display of the actual temperature inside the cabinet; The range is 0
℃
~37
℃
or
32
℉
~99
℉
.
·
℃
/
℉
light:
When the
℃
light is on, it indicates Celsius temperature; When the
℉
light is on, it
indicates Fahrenheit temperature.
•
Button Operation
• SET Button:
Temperature setting button; Once you press the button, the temperature increase 1
℃
or
1
℉
. Setting range is between 5
℃
~22
℃
or 41
℉
~72
℉
.
• LIGHT Button:
Cabinet light control button; Note: Once the light is turned on, it will automatically
off after 10 minutes all out of protecting the wines inside.
•
℃
/
℉
Button:
Celsius and Fahrenheit conversion button;
• ON/OFF button:
Power on and off button; Press the button, it starts; press it again, it stops.