Klarstein 10006585, Руководство пользователя

Страница: 9 / 10

A) After pressing the “Mode” button, if the symbol “ ” is blinking, then press “+” or “-“ to set the
room temperature, the setting temperature range is from 15 ℃ to 35 ℃
Attention: When you set the room temperature, please make sure the set temperature is higher than
the room temperature, or the product will not work normally. When the set temperature is low than the
room temperature- the temperature sensor is sensing about 2 degrees centigrade- the half sun or total
sun signs disappear, under this condition, the heater works normal.
B) After pressing the “Mode” button, if the symbol “ ” is blinking, then press “+” or “-“ to set the timer,
the setting timer range is from 0-24 hours. After setting the timer, the symbol keeps blinking. When the
timer has reached the set time, it sets back to zero (00) itself, and the time symbol will stop blinking.
Assembly
1. For free standing:
1. First, take the heater out of the package and place it upside down on soft surface.
2. Second, take two screws from the accessories (one screw for each castor, parallel the bevel
of castor bracket to the bevel of the heater, if installed reversely, the screw cannot be
revolved in.) and aim them at the taps to tighten them.
3. Then just upright the heater and put it into use. You may refer to the following figure.
2. FOR WALL MOUNTING:
1. First , use an electric drill to drill two holes on the wall. Diameter and depth for the drilling
holes are respectively 8mm and 35mm, the distance between the two drilling holes is
120mm.
2. Second , insert the plastic bulged screw into the drilling hole, then aim the screw at the
hole and fix it on the wall. The screw head shall be about 6mm above the wall surface (To
ensure safety, the screw shall be well fixed.).
3. Third , find the two holes locations on the handle at the rear of the heater and fix them to
the pre-fixed screws. Pull the heater rightward to make the screws tally with the holes
locations.
Note: If wall mount method is adopted, installation of truckles is not allowed. The mounting
location shall be 15cm above the floor and 50cm beneath the ceiling or more. You may refer to the
following figure.