23
Using the dishwasher
EN
!
!
1. A cycle that is underway can only be modified if it has only been running
for a short time. Otherwise, the detergent may have already been
released, and the appliance may have already drained the wash water. If
this is the case, the detergent dispenser must be refilled (see the section
entitled „Loading the Detergent“ ).
2. Open the door, press the P-button to enter the washing programme
display, then press the Page-up or Page-down button to change the
program to the desired cycle setting (see the section entitled „ Starting a
wash cycle. . .“ ).
1. The audio signal will ring 8 times.
2. Turn the dishwasher off using the ON/OFF-button.
3. Before taking out the dishes we recommend that you wait at least
five-
teen minutes
in order to avoid taking out dishes that still may be hot or
fragile. The dishes are also better dry if you leave it longer in the
open
dishwasher.
4. Open the door and take the dishes out.
1. Slowly
open the door of the dishwasher and wait until the spray arms
stop working. (Risk of burns)
2. Now you can fully open the door and additionally load the dishes in the
dishwasher.
The change of the washing program should be carried out
immediately after the start of the program, otherwise the tab-
lets could be already solved or hot water may be leaking.
The additional loading of the dishes in the dishwasher is only possi-
ble when the washing program has just been started, otherwise the
detergent may leak and the water leak.
4.2 Changing the washing program
4.3 At the end of the washing program
4.4 Additional loading of dishes
