Gewerbliches inhaltliches Kopieren verboten!
If all the above checks fail to remedy the
fault, it is possible you have a more seri-
ous problem.
In no circumstances try to repair the
electronic/electrical components in the
appliance.
Contact your Customer Service.
Motor problems
• Is there a power supply failure?
• Is the plug properly inserted in the
socket?
• Has a fuse blown?
The hood capacity is insuficient
/ operating noise has increased
• Is the size of the exhaust air pipeline
suficient?
• Is the exhaust air duct blocked?
• The cross section of the air pipeline
from the hood to the wall box incl.
should be
mm.
• A smaller air pipeline cross-section
can possibly impair the motor power.
• The air low can be obstructed if the
wall box is itted with a ly mesh.
• If this is the case remove the ly mesh.
• If the cover plate of the wall box
has ixed, very inclined louvres, you
should remove the plate to check
whether this solves the problem.
• Mount a cover plate with movable lou-
vres in the wall box, as this will least
obstruct the air low.
• Is / are the ilter s clean?
• Was / were the carbon ilter s
installed more than six months ago?
Then this/these should be changed.
• Is the air taken from the kitchen being
replaced by suficient fresh air, so that
no partial vacuum is being produced
in the room?
When the lightning fails
• Does the lamp need changing?
• Has the lamp been properly itted and
seated in the holder up to the stop?
• Is the fuse blown or has the circuit
breaker tripped out?
. Fault – what to do if ...
. Customer service
Fault – what to do if...
’or technical queries concerning your
appliance please contact the customer
service ofice of your dealer.
The type and rating plate is located in-
side the appliance remove the grease
ilter
EN
Gewerbliches inhaltliches Kopieren verboten!
