Kiyo ProPark XT, Инструкция по установке и эксплуатации

Страница: 8 / 16

6
Sensor
Power cable
Indoor unit Sensor
After following the previous instructions and successfully deter-
min-ing locations and the number of transponders, the next step
is to find a suitable location for the brackets. (If necessary, remove
the bump-er or the grille of the bumper.) The brackets can be fixed
with the help of the packaged screws or with the Velcro tapes (in the
latter case, the drilling of the bumper is not necessary).
Place the transponders into the bracket and with the special adjust-
ment screws align them according to the rules mentioned before.
NEVER drill the transponders!
Lead the cables of the transponders through the car into the cabin.
The cables must not touch any rotating, moving or hot part of the car
(radiator, fan, engine block)! The cables must not strain, but cannot
be loose either! They can be fastened with the packaged cable ties.
Never knot or break the cables! Damaged cables may result in the
malfunction of the transponder and the interface, which might result
in losing the warranty.
With the help of the double-sided adhesive, place the indoor unit
(interface) of the KIYO ProPark XT Parking Assistant in the cabin of
the car. It can be placed above or below the dashboard; you decide
which spot is more suitable for you. By using an auxiliary switch, the
interface can be installed hidden behind the dashboard, but in this
case, only the sound signal warns the driver to the dangers. In case
of a stealth installation, the Parking Assist can be turned on or off
with this auxiliary switch.