9
If the license plate frame of the vehicle is angled, then for the best efficiency, the sensors
have to be aligned to be parallel with the road. The angle of the sensors can be adjusted
with the screw on the side of the mounting bracket.
To maintain the optimal detection efficiency, the license plate frame must be kept clear
of mud, bugs and other contaminations. There may be situations, when the device
signals too late or not at all (f.e.: strong solar radiation, refraction, rainy weather, snow,
contaminated sensors).These are not caused by the malfunction of the device, but by the
law of physics.
a)
Remove the original license plate frame of the car!
b)
Try on the special license plate frame to the car.
The thicker part of the frame holds the sensors and for the best aesthetic view, ensure
that this part goes to the bottom. If the license plate is fastened to the bumper, you may
put the sensors to the upper part of the frame, to be closer to the middle of the car.
Horizontal road
Adjusting
screw
Sensor
Mounting
bracket
►
►
►
Fastening screw
►
