Kiwi KFAN 7509, Инструкция по эксплуатации

Страница: 5 / 24

5
KFAN 7509 User Manual
EN
1. Un-screw to remove the blade spinner from the motor shaft .
2. Un-screw the guard-mounting nut from the front of the motor housing.
3. Position the rear guard against the front of the motor housing with the handle uppermost, ensuring
that the locating pegs on the motor housing are engaged correctly in the holes in the guard.
4. Screw the guard mounting nut firmly onto the projecting thread on the motor housing, make sure
you tighten it firmly.
5. Remove and discard the PVC sleeve on the motor shaft.
6. Place the fan blade onto the motor shaft, locating the slot at the back of the blade on the drive pin
that pass through the motor shaft.
7. Position the front guard against the rear guard so that the holes int he rims that accept the small
nut and bolt are in line. Insert the bolt through the holes and screw on the nut. Do not fully tighten
at this stage.
8. Move the guard retaining clips into position ensuring that they engage correctly on the rim of the
guard.
9. Fully tighten the small nut and bolt that passes through the rim of the guard
Operating instructions
1. Plug the power cord into a suitable socket
2. Tilt the head up or down to the required position by using a locking mechanism that will hold the
head in the desired position.
3. The fan is switched on using the push buttons on the switch housing, i.e.
0 = Off, 1 = Low Speed, 2 = High speed.
Oscillation Control
1. Push the oscillation knob to oscillate
2. Pull the oscillation knob to stop
Special Attention:
1. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
2. Children should be supervised to ensure that they do not play with the appliance
ASSEMBLY OF BLADE AND GUARD