1. Select a dry, level site and clear
the ground of any sharp objects.
Remove the shelter from its
carry bag, untie fabric ties and
unroll the shelter.
2. Spread out the tent and peg out
the four main corners ensuring
the tent is pulled taut and
square.
3. Unroll the webbing straps from
the corners and connect them to
the side release buckles on the
corresponding corner. This stops
the corners from ‘splaying’ out
when the shelter is inflated.
Your tent includes:
27 x pegs
4 x guy ropes
8 x webbing ropes
Domain Shelter
Model No. KC074-818
4. Screw the valve into the
air tube and then unscrew
the valve cap that is on
the top. Insert the pump
hose into the valve and
inflate. You may need to
help the tube stand up so it
inflates evenly. Inflate the
middle tube first then move
to the front and then the
back. Make sure you only
inflate to the recommended
pressure (6-8psi) as over
inflation can lead to tube
damage. Only use the
pump provided as it has
a pressure gauge which
shows the recommended
pressure.
5. Step back and check the
shelter is square. If so,
peg out the remaining
pegging points on the four
corners first, followed by
the curtains. It is important
to rope out the guy ropes
and webbing ropes on all
sides to support the shelter
in place.
6. The Domain air frame
shelter is designed for short
stays - overnight camps
and day trips. Due to the air
frame design it is not suited
for long camping periods.
7. Fine tune the cover so it remains taut and positioned correctly
over the frame.
PITCHING INSTRUCTIONS
Filename: 4825_KC074-818_Domain Shelter_Instr.pdf
Dimensions: 280mm W x 150mm H
Colour: Black
PACKING INSTRUCTIONS
REVERSE THE PROCEDURE TO LOWER THE SHELTER
Pull out the pegs leaving the 4 corner pegs in.
Unscrew the valve caps letting out all the air - make sure all the air
escapes and then lay the roof evenly on the floor as flat as you can as
this will make the shelter easier to fold.
Lay flat
Fold once
Fold twice
Roll
Fold again
