8
9
Bluetooth pairing
Press and hold down the volume dial until the green light starts to flash and a beep is heard.
When the green light is flashing, it means the Soul is in pairing mode. Go to the Bluetooth
menu on your phone and make sure Bluetooth is switched on. Then search for new devices and
‘Soul’ should appear in the list. Select this and if asked for a passcode, enter ‘0000’. The Soul will
then be paired to your device.
When turning the speaker back on again, it will automatically search for and connect to any paired
devices within range. If no devices are found, the Soul will remain in pairing mode until a device is
connected or the Soul is switched off.
Using the speaker
1. Turn on
Press and hold down the volume dial until the green light comes on
2. Turn off
Press and hold down the volume dial until the green light goes off
3.
Twist the volume dial in a clockwise direction
4. Volume –
Twist the volume dial in an anti-clockwise direction
5. Play/Pause
*
Press down (do not hold) the volume dial
*
This feature is only available if you phone supports Bluetooth profile AVRCP.
Check your handset/tablet manual if unsure.
Aux-in
Use a 3.5 mm aux-in cable to connect your Bluetooth speaker through the aux-in socket at the
bottom of the unit.
Note:
When you plug the aux-in cable into the aux-in socket, the current Bluetooth connection will
disconnect. When you unplug the aux-in cable, the Bluetooth connection will resume.
