6
7
Instructions for use
Getting started
To connect the two speakers together
1. Insert the 4 pin XLR cable into the 4 pin XLR port (14) and tighten the connection
2. Insert the other side of the cable into the same port on the slave speaker and tighten the connection
To connect the speaker to power
1. Insert the figure 8 cable into the Mains power port (13)
2. Insert the UK plug into a plug socket
3. To turn the speakers on, flick the On / Off switch (12) to ‘On’ and the Parallax will enter standby mode,
and the Bluetooth LED (4) will be solid red
Using the remote
Please ensure the remote is pointing directly to the remote sensor (K) and nothing is blocking it.
Controls
Mute
Short press Mute (C)
Change volume
Short press Increase / Decrease volume (3/I)
Change bass
Short press Bass (G), or press Mode (2) and then Increase / Decrease Volume (3).
The Bass LED will be solid green
Change treble
Short press Treble (H), or press Mode (2) and then Increase / Decrease Volume (3).
The Treble LED will be solid green
Default settings
Short press Reset (D)
Bass and treble controls
To change the bass and treble on the top panel of the speaker:
1. Short press Mode (2) once and the Bass LED (7) will be solid green
2. Short press Mode (2) twice and the Treble LED (8) will be solid green
3. Short press Increase / Decrease volume (3) to increase / decrease the bass / treble
Your Parallax speakers are now in standby mode and are ready to use.
Standby mode
To turn on from standby mode, short press Power (1/A) and the Bluetooth LED (4) will flash red and then enter the last mode
it was in. To return to standby mode, short press power (A) on the remote or long press Power (1) for five seconds until the
Bluetooth LED (4) is solid red.
Connecting through Bluetooth
1. When Parallax speakers are on, the Bluetooth LED (4) will flash blue, automatically entering pairing mode
2. Turn your device’s Bluetooth ON and search for new devices
3. Select ‘KS Parallax’. If asked for a passcode, enter ‘0000’, and they will be paired
4. Once paired the Bluetooth LED indicator (4) will be solid blue
Note:
The Parallax will automatically connect to the last paired device.
Note:
‘Bluetooth’ is a trademark of Bluetooth SIG, Inc. This product is in no way affiliated with or endorsed by Bluetooth SIG Inc.
Connecting through NFC
If your device is NFC enabled, when the Parallax is in pairing mode, hover your device over the NFC hotspot (9)
and this will connect.