KITO EDIII ED06S, Оригинальная инструкция

Страница: 13 / 44

— 11 —
To avoid damage on the curled cord, fix the curled cord to the chain container with the fixing band.
To avoid wear between load chain and chain guide straighten up load chain before fitting the curled cord to
the chain container.
To avoid damaging the curled cord, attach the chain container so that the fastening belt clamp faces up.
(4) Lubricating the load chain
Chain lubrication is a critical factor in the service life of a load chain. Apply enough machine or gear oil
regularly.
Lubrication Procedures
･
Vertically suspend the chain under no load conditions.
･ Remove dust or water drops from the chain
･
Apply lubricant around the sections where the chain links come into contact with each other and the
load sheave or idle sheave as shown in the following figures.
(5) Power supply cable specifications
Use a power supply cable of an outer diameter specified in the below table in relation with a distance to
power source.
Use a three conductors cable including Ground wire as for power supply cable.
Power supply cable diameter
(normal cross-section area of
conductor)
Max. length of power
supply cable
(m)
2.0mm
2
30
1.25mm
2
15
[Connection to power supply source]
ALWAYS
ground the electric chain hoist before using.
NEVER
ground the electric chain hoist to a gas pipe as this can create the possibility of explosion.
In addition to grounding,
ALWAYS
connect to a power supply source equipped with an earth leakage breaker.
Actual power source voltage should not exceed max. allowable voltage: 264V
WARNING
WARNING
Load-applying
direction
・ After the chain lubrication is done, lift and lower without
any load to spread the lubricant thoroughly.
Please consult with KITO Corporation if any of
lubricants are not allowed at your site.
CAUTION