structures, can make the sounds seem louder. The following
describes the kinds of sounds and what may be making them.
Your beverage center is designed to run more effi ciently to
keep your beverages at the desired temperatures and to
minimize energy usage. The high effi ciency compressor and
fans may cause your beverage center to run longer than
your old one. You may also hear a pulsating or high-pitched
sound from the compressor or fans adjusting to optimize
performance.
Rattling noises may come from the fl ow of refrigerant or
items stored inside the beverage center.
As each cycle ends, you may hear a gurgling sound due to
the refrigerant fl owing in your beverage center.
You may hear water running into the drain pan when the
beverage center is defrosting.
You may hear clicking sounds when the beverage center
starts or stops running.
Rack 1:
For storing up to eight 750 ml wine bottles [diameter
less than or equal to 3
1
/
8
” (80 mm)].
Rack 2:
For storing up to 6 wine bottles [diameter up to 3
1
/
8
”
(80 mm)].
1
2
Stocking the Beverage Center
1.
Starting on the left-hand side, place the first bottle on the
bottom of the rack with the neck of the bottle facing the
front of the beverage
center.
2.
Place the next bottle on
its side with the neck of
the bottle facing the
back of the beverage
center. Alternate the
direction of the bottles,
in this manner, until the
display rack is full.
To stock the Beverage Center - Rack 2:
1.
Starting from left-hand side of the bottom rack, place
the first bottle with the
neck of the bottle facing
the front of the
beverage center.
2.
Continue to place the
remaining bottles facing
in the same direction.
Wine Racks
Remove and replace the racks:
1.
Pull the rack forward until it stops.
2.
Press down on the left-hand lever while lifting up on the
right-hand lever to release the rack. Pull the rack forward
and lift it up and out of the rack supports.
A
A. Lever
9
To stock the Beverage Center Shelves:
Place juices, sodas or other canned beverages on the
glass shelves.
To stock the Beverage Center - Rack 1:
NOTE:
The wine rack can be stocked with the bottles facing
either direction, however, to optimize storage adjacent bottles
should be facing in opposite.
3.
Replace the rack by inserting the rack into the supports
and sliding it in until it locks.