Electrical &
water supply
requirements
A 120-volt, 60-Hz, AC-only, 15- or
20-ampere, fused, electrical supply is
required. A time-delay fuse or circuit
breaker is recommended. It is
recommended that a separate circuit
serving only this appliance be
provided.
This appliance is equipped with a
power supply cord having a 3-prong
ground plug. To minimize possible
shock hazard, the cord must be
plugged into a mating 3-prong,
ground-type outlet, grounded in
accordance with the National
Electrical Code, ANSI/NFPA 70 —
latest edition
*
or Canadian Electrical
Code, C22.1-1982 and C22.2 No.
01982 (or latest edition)
**
, and all
local codes and ordinances.
Copies of the standard listed may
be obtained from:
* National Fire Protection Association
One Batterymarch Park
Quincy, Massachusetts 02269
**
CSA International
8501 East Pleasant Valley Road
Cleveland, Ohio 44131-5575
Electrical requirements
ground
prong
power supply
cord
retainer
Water supply requirements
Water line to refrigerator must
provide 15-100 psi (103-690 kPa)
water pressure.
Provide water line hookup located as
shown on Page 3.
Page 8
3-prong ground-type
outlet
3-prong
ground plug
If codes permit and a separate
ground wire is used, it is
recommended that a qualified
electrician determine that the
ground path is adequate.
Do not ground to gas pipe.
Check with a qualified electrician if
you are not sure the appliance is
properly grounded.
Do not have a fuse in the neutral or
ground circuit.
It is the customer’s responsibility:
To contact a qualified electrical
installer.
To assure that the electrical
installation is adequate and in
conformance with the National
Electrical Code, ANSI/NFPA 70 —
latest edition* or Canadian Electrical
Code, C22.1-1982 and C22.2 No.
01982 (or latest edition)**, and all
local codes and ordinances.
WARNING
Electrical Shock Hazard
Plug into a grounded 3-prong
outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these
instructions can result in death,
fire, or electrical shock.
