ENGLISH
USING THE STAND MIXER
|
13
USING THE STAND MIXER
PLACING/REMOVING THE POURING SHIELD*
1
To place pouring shield:
Turn speed
control to “0”� Unplug Stand Mixer�
Attach your chosen accessory� See
the “Attaching/removing the flat
beater, Flex Edge beater, wire whip,
or dough hook” section�
2
From the front of the Stand Mixer,
slide the pouring shield over the
bowl until the shield is centred� The
bottom rim of the shield should fit
within the bowl�
*Included with select models only� Also available as an optional accessory�
BEATER TO BOWL CLEARANCE
1
Turn speed control to “0”� Unplug
Stand Mixer�
2
Lift motor head� Turn screw slightly
counterclockwise (left) to raise flat
beater or clockwise (right) to lower
flat beater� Make adjustment with
flat beater, so it just clears surface
of bowl� If you overadjust the screw,
the bowl lock lever may not lock
into place�
Your Stand Mixer is adjusted at the factory so the flat beater just clears the bottom of the
bowl� If for any reason the flat beater hits the bottom of the bowl or is too far away from
the bowl, you can correct the clearance easily�
NOTE:
When properly adjusted, the flat beater will not strike on the bottom or side
of the bowl� If the flat beater or the wire whip is so close that it strikes the bottom
of the bowl, coating may wear off the beater or wires on whip may wear�
W11256121A.indd 13
14/06/2018 15:29:26
Содержание KSM150PS - Artisan Series Mixer
Страница 2: ...W11256121A indd 2 14 06 2018 15 29 21 ...
Страница 43: ...W11256121A indd 43 14 06 2018 15 29 36 ...
