KitchenAid KRSC 9010, Руководство по сборке

Страница: 5 / 12

The refrigerator has two front and two rear
wheels, located on each side at the bottom of
the appliance, that can be adjusted (see figure
A), or four wheels, of which only the two
front ones are adjustable (see figure B).
If the appliance seems unsteady or you want
the doors to close more easily, it is advisable
to adjust the inclination of the appliance
following the instructions given below
(depending on the model, as shown in the
figures opposite).
1. Check the installation position in order to
guarantee a space of at least 1 cm on all sides
including the top.
2. Connect the appliance to the power supply.
3. Move the refrigerator into its final position.
4. Open both doors and remove the kickplate to
access the levelling screws on the left and right
of the refrigerator base. The top screw (
I )
adjusts the rear wheel, if present, whereas the
bottom screw (
2 ) adjusts the front wheel.
5. Use the wrench provided to adjust the levelling
screws. Turn clockwise to raise the appliance,
or anticlockwise to lower it. The levelling
screws may have to be turned several times to
adjust refrigerator inclination.
Note: Do not unscrew the levelling screws too
much when lowering the appliance, otherwise
they could come out.
Aligning the doors :
If, after switching on the appliance and adjusting
the refrigerator and freezer doors, the doors are
misaligned, disconnect the appliance from the
power supply and adjust them as indicated in the
attached diagram.
Figure A
Figure B
Refrigerator levelling
5
501910200330_INST_GB_Sbs.qxp 20-11-2007 15:21 Pagina 5