KitchenAid KOHCP-60600, Инструкция по эксплуатации

Страница: 11 / 32

11
Cleaning
• If the oven is installed below a hob, ensure that
all burners or electric hotplates are switched
off during the self-cleaning (pyrolysis) function
• Remove all accessories before running the
pyrolysis function (including the lateral grids).
• For optimum cleaning of the oven door,
remove the worst soiling with a damp sponge
before using the pyrolytic function.
The appliance is equipped with 2 pyrolysis
functions:
1. Energy-saving cycle (PYRO EXPRESS/ECO):
which consumes approximately 25 % less
energy than the standard cycle. Select it at
regular intervals (after cooking meat on 2 or 3
consecutive occasions).
2. Standard cycle (PYRO): which is suitable for
cleaning a very dirty oven.
• In any case, after a certain number of uses
and depending on how dirty the oven is, a
message on the oven display advises you
to run a self-cleaning cycle.
N.B: during the pyrolysis function, the oven
door will not open; it will remain locked until
the temperature inside the oven has returned
to an acceptably safe level.
–
Use protective gloves.
–
Ensure that the oven is cold before carrying out the following
operations.
– Disconnect the appliance from the mains power supply.
WARNING
REMOVING THE DOOR
To remove the door:
1. Open the door fully.
2. Lift the catches and push them forwards as far as they will go (fig. 1 ).
3. Close the door as far as it will go (
A
), lift it up (
B
) and turn it (
C
) until it is
released (
D
) (fig.
2
).
To refit the door:
1. Insert the hinges in their seats.
2. Open the door fully.
3. Lower the two catches.
4. Close the door.
Fig. 1
Fig. 2
Maintenance