16
OVEN RACKS
Cleaning Method:
■
Self-Cleaning cycle:
See “High Temp Self-Cleaning Cycle” first. Remove racks or
they will discolor and become harder to slide. If this happens, a
light coating of vegetable oil applied to the rack guides will help
them slide.
■
Steel-wool pad
Oven Lights
The oven lights are 120-volt, 40-watt maximum halogen bulbs.
They will come on when the oven door is opened. The oven lights
will not work during the Self-Cleaning cycle. When the oven door is
closed, touch OVEN LIGHT to turn light on or off.
To Replace:
Before replacing the bulb, make sure the oven is off and cool.
1. Disconnect power.
2. Remove glass light cover by grasping the front edge and
pulling away from oven.
3. Remove bulb from socket.
4. Replace bulb, using tissue or wearing cotton gloves to handle
bulb. To avoid damage to or decreasing the life of the new
bulb, do not touch bulb with bare fingers.
5. Replace bulb cover by snapping back into wall.
6. Reconnect power.
IMPORTANT: Do not use bulbs rated higher than 40 watts.
Oven Door
IMPORTANT:
To avoid oven door glass breakage:
■
Do not close the oven door if the racks are not fully inserted
into the oven cavity or when bakeware extends past the front
edge of an oven rack.
■
Do not set objects on the glass surface of the oven door.
■
Do not hit glass surfaces with bakeware or other objects.
■
Do not wipe down glass surfaces until the oven has completely
cooled.
For normal oven use, it is not suggested to remove the oven door.
However, if removal is necessary, make sure the oven is off and
cool. Then, follow these instructions. The oven door is heavy.
To Remove:
1. Open oven door all the way.
2. Flip up the hinge latch on each side.
3. Close the oven door as far as it will shut.
4. Lift the oven door while holding both sides.
Continue to push the oven door closed and pull it away from
the oven door frame.
To Replace:
1. Insert both hanger arms into the door.
2. Open the oven door.
You should hear a “click” as the door is set into place.
3. Move the hinge levers back to the locked position. Check that
the door is free to open and close. If it is not, repeat the
removal and installation procedures.
