KitchenAid KDDA27TRS, Руководство по установке

Страница: 11 / 32

11
Reinstall the Base Grille
1. Be sure the Power On/Off Switch is on.
2. Reinstall the base grille.
NOTE: The bottom of the base grille has a notch and a wider
flange than the top.
3. Using a Phillips screwdriver, drive the four screws into the
base grille as shown. Tighten all screws.
Complete Installation
1. Remove all boxes, parts packages and packing materials
from the interior of the refrigerator drawers.
2. Remove the protective film.
3. Clean the refrigerator drawers before use. See “Cleaning”
section in the Use & Care Guide for instructions.
4. The controls are preset at the factory to the default setting
37°F (3°C) for the upper and lower drawers. Be sure that the
compressor is operating properly and that all the lights are
working.
5. If construction will continue after the refrigerator drawers
have been installed, turn the power Off for both Drawers. See
“Using the Controls” in the Use & Care Guide for instructions.
To get the most efficient use from your new refrigerator drawers,
read your Use & Care Guide. Keep these Installation Instructions
and Use & Care Guide near the refrigerator drawers for easy
reference.
A. Power On/Off Switch (ON)
A. Bottom flange
A. Screws
A
A
A
A