KitchenAid 9760425A, Инструкция по установке, эксплуатации и уходу

Страница: 9 / 32

4. Install the two vent extension pieces onto the diverter, pushing
them until they stop.
5. Discard the lower chimney cover shipped with the hood and
use the cover from the Recirculating Kit (purchased
separately).
6. Slide the recirculating kit lower chimney cover over the
chimney support and the upper cover. Make sure the diverter
extensions line up with the openings in the cover. Attach the
cover using the two screws provided.
7. Snap vent grilles into place.
Chimney Extension Kit Installation (Optional)
1. Remove the plastic covering from the chimney covers.
2. Discard the upper chimney cover supplied with the hood.
Install Chimney Covers
Vented Installation Option
1. Attach the vent system to the damper. Seal all joints with
duct tape.
2. Remove the plastic covering from the chimney covers.
3. Slide the upper chimney cover over the chimney support and
attach to the top of the support using two screws provided.
4. Slide the lower chimney cover over the chimney support and
the upper cover. Attach to the bottom of the support using
two screws provided.
Recirculating Installation Option, Kit Required
1. Remove the plastic covering from the chimney covers.
2. Slide the upper chimney cover over the chimney support and
attach to the top of the support using two screws provided.
3. Place the diverter from the Recirculating Chimney Kit over the
vent motor exhaust outlet and push down to seat on the
outlet. Make sure the diverter exhaust outlets are parallel with
the vent motor sides so that they will align with the vent cover
openings in lower chimney.
9
A
B
A
A. Vent extensions
A
A. Diverter
B. Vent motor
A. Upper chimney cover
B. Lower chimney cover
C. Screw
A
B
C
A
A. Vent grill location