KitchenAid 720-0787D, Инструкция по установке и руководство по эксплуатации и уходу

Страница: 5 / 97

Installation Requirements
Tools and Parts
Gather these required tools and parts before starting
Location Requirements
installation. Read and follow the instructions provided with
any tools listed here.
Tools Needed

Phillips screwdriver

Wrench or pliers

Pipe wrench

Scissors or cutting pliers (to
remove tiedowns)

Noncorrosive leak-detection
solution
Parts Supplied

Gas pressure regulator/hose assembly set for 11”
WCP LP gas

Right side shelf

Left side shelf

“AA” Battery (1)

Warming rack
solution
g

Cooking grids

Grease cup

Door hinges

Flame tamers

Natural gas orifice for rear burner
Parts Needed

20lb LP gas fuel tank-approximately 18”(45.7cm height)
and 12”(30.5cm) diameter
Parts Needed for Conversion to Natural Gas

Natural gas conversion kit Part Number 710-0003. See
“Assistance” section to order. The conversion kit includes:
N t l l t 4" W C ( k d “N t l G
Select a location that provides minimum exposure to
wind and traffic paths. The location should be away

Natural gas regulator 4" W.C. (marked “Natural Gas
Regulator”)

10 ft (3.0 m) Natural gas hose with quick connector

5.9" (150 mm) Natural gas regulator hose

6 mm nut driver

6 mm wrench

Hex key
G li h t ff l
p y
from strong draft areas.
Do not obstruct flow of combustion and ventilation air.
Clearance to combustible construction for grill:

A minimum of 24” (61 cm) must be maintained
between the front of the grill hood, sides and back of
the grill and any combustible construction.

A 24” (61 cm) minimum clearance must also be

Gas line shutoff valve

1/2" male pipe thread nipple for connection to pressure
regulator.

LP gas-resistant pipe-joint compound

CSA design-certified outdoor flexible stainless steel
appliance connector (4-5 ft [1.2-1.5 m]) or rigid gas
supply line as needed.
maintained below the cooking surface and any
combustible construction.
5