8
2. Install the transition piece using 3 - 4.2 x 8 mm mounting
screws to the range hood canopy.
3. Install the lower support bracket removed in Step 1 using the
10 - 4.2 x 8 mm mounting screws to the range hood canopy.
4. Position the 4 vertical supports (A) with the notches at the
bottom and attach to the range hood using 16 - 4.2 x 8 mm
screws.
5. Attach the horizontal support (B) to the vertical supports (A) in
either the first or third set of holes from the top of the vertical
supports.
6. Attach a second set of vertical supports (A) and set the
vertical height (B). See “Installation Clearances” in the
“Location Requirements” section to help determine the
desired dimension for vertical height “B.”
7. Attach the range hood assembly to the upper horizontal
support attached to the ceiling using 16 - 4.2 x 8 mm screws
and tighten.
8. Install the 4 supports using 8 - 4.2 x 8 mm screws.
NOTE: The notch in the supports (B) must be to the external
side when mounted.
9. Attach the vertical duct cover supports using 4 - 4.2 x 8 mm
screws.
Connect Vent System
1. Install vent system.
2. Push duct over the exhaust outlet. Seal all connections with
vent clamps.
A. Lower support bracket
B. 4.2 x 8 mm mounting screws
C. Transition piece
A. Vertical supports
B. Horizontal support
C. Notched end
A
C
B
B
B
A
A
C
C
A. Vertical supports
B. Vertical height
A. Mounting screws
A. Notch in support
B. Support
C. 4.2 x 8 mm screws
D. Vertical duct cover support
B
A
A
A
D
C
B
A
